Published: 11-May-2011

2007.0 Range Rover Sport (LS), 211-02

Power Steering

Power Steering Pump to Steering Gear Pressure Line - TDV8 3.6L Diesel (G952829)

REMOVAL AND INSTALLATION
Removal
  1. Raise and support the vehicle.
  2. E46253
    Remove the front LH splash shield.
      • Remove the 4 clips.
  3. E85740
    Release the steering gear high-pressure line.
      • Remove the bolt.
  4. Remove the front LH fender splash shield. For additional information, refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
  5. CAUTIONS:

    • Make sure that all openings are sealed. Use new blanking caps.

    • Make sure that the area around the component is clean and free of foreign material.

    E86422
    Disconnect the power steering pump supply hose.
      • Release the clip.
      • Position a container to collect the fluid.
  6. CAUTIONS:

    • Make sure that all openings are sealed. Use new blanking caps.

    • Make sure that the area around the component is clean and free of foreign material.

    E86423
    Disconnect the power steering pump high-pressure line.
      • Remove the bolt.
      • Remove and discard the O-ring seal.
  7. E45637
    Remove the front RH splash shield.
      • Remove the 4 clips.
  8. CAUTIONS:

    • Make sure that the area around the component is clean and free of foreign material.

    • Make sure that all openings are sealed. Use new blanking caps.

    E72353
    Disconnect the high-pressure line from the power steering gear.
      • Remove and discard the bolt.
      • Remove and discard the O-ring seal.
  9. Remove the steering gear high-pressure line.
Installation
  1. Install the steering gear high-pressure line.
  2. NOTE:

    Remove and discard the blanking caps.

    Connect the high-pressure line to the power steering gear.
      • Install a new O-ring seal.
      • Tighten the new bolt to 22 Nm (16 lb.ft).
  3. Install the front RH splash shield.
      • Secure with the clips.
  4. NOTE:

    Remove and discard the blanking caps.

    Connect the high-pressure line to the power steering pump.
      • Install a new O-ring seal.
      • Tighten the bolt to 25 Nm (18 lb.ft).
  5. NOTE:

    Remove and discard the blanking caps.

    Connect the power steering pump supply hose.
      • Secure with the clip.
  6. Install the front LH fender splash shield. For additional information, refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
  7. Secure the steering gear high-pressure line.
      • Tighten the bolt to 10 Nm (7 lb.ft).
  8. Install the front LH splash shield.
      • Secure with the clips.
  9. Fill and bleed the power steering system. For additional information, refer to: Power Steering System Filling and Bleeding (211-00 Steering System - General Information, General Procedures).