Published: 11-May-2011

2007.0 Range Rover Sport (LS), 307-02D

Transmission/Transaxle Cooling - TDV8 3.6L Diesel

Transmission Fluid Cooler Pipes (G946683)

REMOVAL AND INSTALLATION
  • 44.24.15
  • Transmission Fluid Cooler Pipes - Renew
  • TDV8
  • 4.80
  • USED WITHINS
Removal
  1. Raise and support the vehicle.
  2. Remove the front axle assembly. For additional information, refer to: Axle Assembly - TDV8 3.6L Diesel (205-03 Front Drive Axle/Differential, Removal and Installation).
  3. E45739
    Remove the radiator splash shield.
      • Remove the 4 bolts.
  4. CAUTION:

    Make sure that all openings are sealed. Use new blanking caps.

    E86039
    Disconnect the 2 transmission fluid cooler tubes from the transmission fluid cooler.
      • Position a container to collect the fluid spillage.
      • Release the 2 quick release connectors.
  5. E85117
    Release the transmission fluid cooler tubes bracket.
      • Remove the nut.
  6. CAUTION:

    Always plug any open connections to prevent contamination.

    E46532
    Remove the 2 transmission fluid cooler tubes.
      • Remove the bolt.
      • Remove and discard both O-ring seals.
Installation
  1. NOTE:

    Remove and discard the blanking caps.

    Install the transmission fluid cooler tubes.
      • Clean the components.
      • Install the new O-ring seals.
      • Tighten the bolt to 10 Nm (7 lb.ft).
  2. Secure the transmission fluid cooler tubes bracket.
      • Tighten the nut to 10 Nm (7 lb.ft).
  3. NOTE:

    Remove and discard the blanking caps.

    Connect the transmission fluid cooler tubes to the transmission fluid cooler.
      • Remove the container.
  4. Install the radiator splash shield.
      • Tighten the M6 bolts to 10 Nm (7 lb.ft).
      • Tighten the M10 bolts to 62 Nm (46 lb.ft).
  5. Check and top-up the transmission fluid level. For additional information, refer to: Transmission Fluid Level Check (307-01A Automatic Transmission/Transaxle - V8 S/C 4.2L Petrol, General Procedures).