Published: 13-Mar-2018

2007.0 Range Rover Sport (LS), 204-01

Front Suspension

Stabilizer Bar Link (G2249390)

REMOVAL AND INSTALLATION

Part(s)

StepPart nameQualificationQuantity
Step 1Stabilizer bar link upper and lower nutsVehicles without Active Stabilization1
Step 2Stabilizer bar link upper and lower nutsVehicles with Active Stabilization1
Removal
  1. WARNING:

    Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.
  2. Remove the wheel and tire.
  3. CAUTIONS:

    • Note the position of the hardened steel washer. The hardened steel washer must be installed between the stabilizer bar link and the stabilizer bar. Failure to follow this instruction may result in damage to the vehicle.

    • Use a Torx socket to prevent the ball joint rotating whilst installing the nut.

    E57354
    Release the stabilizer bar link. Remove and discard the nut.
  4. CAUTIONS:

    • Note the position of the hardened steel washer. The hardened steel washer must be installed between the stabilizer bar link and the upper arm. Failure to follow this instruction may result in damage to the vehicle.

    • Use a Torx socket to prevent the ball joint rotating whilst removing the nut.

    E58529
    Remove the stabilizer bar link. Remove and discard the nut.
Installation

The following step(s) applies to:
Vehicles without Active Stabilization

  1. CAUTIONS:

    • Make sure the hardened steel washers are installed between the stabilizer bar link and the stabilizer bar, and between the stabilizer bar link and the upper arm. Failure to follow this instruction may result in damage to the vehicle.

    • Use a Torx socket to prevent the ball joint rotating whilst installing the nut.

    Install the stabilizer bar link. Install new nuts and tighten.
    Renew Part: Stabilizer bar link upper and lower nuts Quantity: 1.
    Torque: 175Nm

The following step(s) applies to:
Vehicles with Active Stabilization

  1. CAUTIONS:

    • Make sure the hardened steel washers are installed between the stabilizer bar link and the stabilizer bar, and between the stabilizer bar link and the upper arm. Failure to follow this instruction may result in damage to the vehicle.

    • Use a Torx socket to prevent the ball joint rotating whilst installing the nut.

    Install the stabilizer bar link. Install new nuts and tighten.
    Renew Part: Stabilizer bar link upper and lower nuts Quantity: 1.
    Torque: 175Nm

The following step(s) applies to:
All vehicles

  1. Install the wheel and tire.